Use this URL to cite or link to this record in EThOS:
Title: Optimisation of the squeeze forming process
Author: Ahmad, Rosli
Awarding Body: University of Wales, Swansea
Current Institution: Swansea University
Date of Award: 2006
Availability of Full Text:
Access from EThOS:
Full text unavailable from EThOS. Please try the link below.
Access from Institution:
This thesis presents the optimisation of the squeeze forming process, considering both the thermal and mechanical aspects. The Finite Element Method has been used to simulate the process and a Genetic Algorithm was used as an optimisation tool. The thermal optimisation has been applied to the squeeze forming process to achieve near simultaneous solidification in the cast part. The positions of the coolant channels were considered as design variables in order to achieve such an objective. The formulation of the objective functions involved two points and also considered the whole domain. The validation aspects of the optimisation of the casting processes for 2D and axi-symmetric problems were presented. The influence of the interfacial heat transfer coefficient related to optimisation of the process was explored. For the multi-objective optimisation problem, the objective was to achieve near simultaneous solidification in the cast part and also near uniform von Mises stress distribution in the die for the first and also tenth cycles. This is because it has been found that the process starts to reach cyclic stabilisation after the tenth cycle. The comparison between the design obtained from the practical solution derived from the optimisation process and also the design which has been applied in industry was also discussed. The Design Sensitivity Analysis and Design Element Concept have been applied to the squeeze forming process. For parameter sensitivity analysis, the Youngs Modulus was considered as a design variable. A few design element subdivisions have been employed to explore its application to the process. For shape sensitivities involving the coolant channels, the parameterisation was required in order to consider the coolant channel as an entity. The extent to which the tendency to move the coolant channel either in the X or Y-direction with respect to the particular von Mises stress constraint in the die was also discussed.
Supervisor: Not available Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID:  DOI: Not available