Use this URL to cite or link to this record in EThOS:
Title: V-band joint torsional load capacity
Author: Sahboun, Salahaddin
ISNI:       0000 0004 5918 1010
Awarding Body: University of Huddersfield
Current Institution: University of Huddersfield
Date of Award: 2015
Availability of Full Text:
Access from EThOS:
Full text unavailable from EThOS. Thesis embargoed until 01 May 2018
Access from Institution:
This research thesis presents an analysis of the torsional loads on V-band clamps. In some applications, the relative rotational movement of the flanges connected by V-band clamps can result in catastrophic system failure. The ability to understand the factors impacting on torsional load capacity is therefore essential. In this research project, a theoretical model of a V-band joint subjected to torsional loads was developed. This model is used to identify those parameters that will impact on the joint’s reliability. An experimental investigation was conducted to validate a theoretical model using a newly developed test rig. The development and features of this test rig are presented in this report. This experimental investigation also allowed the impact of those parameters that are difficult to control, to be determined. A total of three V-bands were used with different diameters but nominally identical cross sections were studied. In the research results, the initial slip point between flanges and the V-band clamp was identified by experimentation within this research project. Different sizes of Vbands were used under boundary conditions and loads. From the simulation results it was determned that the friction effect on the V-band depends on the size of the V-band. For the largest size of V-band, there was moderate correlation of the experimental and theoretical results. For the smallest size, the results suggest that with band tightening, flange contact is localised, rather than being throughout the band’s entire circumference. The research demonstrated the significant relevance of the band and flanges’ contact points and the coefficient of friction, especially that between the flanges, on the V-band clamp’s theoretical torsional load capacity.
Supervisor: Barrans, Simon Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID:  DOI: Not available
Keywords: T Technology (General)