Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.647182
Title: Large plate monitoring using guided ultrasonic waves
Author: Ghandourah, E. I. I.
ISNI:       0000 0004 5365 6126
Awarding Body: University College London (University of London)
Current Institution: University College London (University of London)
Date of Award: 2015
Availability of Full Text:
Access through EThOS:
Full text unavailable from EThOS. Please try the link below.
Access through Institution:
Abstract:
Areas of stress concentration around welded structures are likely to lead to fatigue cracks and corrosion pitting during the life time of technical machinery. Performing periodical non-destructive testing of the critical area is crucial for the maintenance of structural integrity and the prevention of unforeseen shutdowns of the system. Low frequency guided ultrasonic waves can propagate along thin structures and allow for the efficient testing of large components. Structural damage can be localized using a distributed array of guided ultrasonic wave sensors. Guided waves might be employed to overcome the accessibility problem for stiffened plate structures where access to some parts of the inspected structure is not possible. The transmission and reflection of the A0 Lamb wave mode for a variation of the stiffener geometry and excitation frequency was investigated numerically and verified experimentally. The dispersive behaviour of the guided waves has been studied to ascertain a frequency thickness product that provides limited pulse distortion. The limitations of the plate geometry as well as the excitation and monitoring locations were discussed. The radial spreading of the incident, transmitted and reflected waves from a stiffener has been investigated. The efficient quantification of the transmitted and reflected waves from the stiffener for a wide range of angles has been obtained from a single Finite Element model containing two parallel lines of nodes in front of and past the stiffener. The research outcomes have shown the dependency of the scattered wave on the incident angle and stiffener dimensions. Reasonably good A0 wave mode transmission was obtained from the oblique wave propagation (up to an angle of 45o) across realistic stiffener geometries. The choice of an optimum excitation frequency, which can ensure maximum transmission across the stiffener for specific plate geometry, was recommended. The ability for defect detection in inaccessible areas has been investigated numerically and validated experimentally. The possibility of detecting and characterizing the reflection of a guided wave pulse (A0 mode) from a through-thickness notch located behind the stiffener has been discussed. Two different approaches, based on the access to the sides of the stiffener on the plate, were employed. The limitations of the detectable defect size and location behind the stiffener have been investigated. The energy of the transmitted wave across the stiffener was adequate to detect simulated damage behind the stiffener. The evaluation has shown that defect detection in inaccessible areas behind stiffeners is achievable if the signal-to-noise ratio is high enough. In experimental measurements the noise level was of similar magnitude to the observed reflections at the defect. Thus, there is necessity to enhance the signal-to-noise ratio in experimental measurements.
Supervisor: Not available Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.647182  DOI: Not available
Share: