Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.577971
Title: Mathematical modelling, flight control system design and air flow control investigation for low speed UAVs
Author: Elgayar, Ibrahim
Awarding Body: City University London
Current Institution: City, University of London
Date of Award: 2013
Availability of Full Text:
Access through EThOS:
Access through Institution:
Abstract:
The demand for unmanned aerial vehicles (UAVs) has increased dramatically in the last decade from reconnaissance missions to attack roles. As their missions become more complex, advances in endurance and manoeuvrability become crucial. Due to the advances in material fabrication, wing morphing can be seen as an ideal solution for UAVs to provide improvements by overcoming the weight drawback. This thesis investigates the area of aircraft design and simulation for low speed UAVs looking at performance enhancements techniques for low speed UAVs, and their effects on the aerodynamic capabilities of the wing. The focus is on both suitable control design and wing morphing techniques based on current research findings. The low speed UAV X-RAE1 is used as the test bed for this investigation and is initially analytically presented as three dimensional body where the equations relate to the forces and moments acting on the UAV. A linearised model for straight flight at different velocities is implemented and validated against a non-linear model. Simulations showed the X-RAE1 to have acceptable stability properties over the design operating range. Control design techniques, linear quadratic regulators (LQR) and H-infinity optimisation with Loop Shaping Design Procedure (LSDP), are used to design simple control schemes for linearised longitudinal model of the X-RAE1 UAV at different velocities. The effectiveness and limitations of the two design methods show that both designs are very fast, with settling times 2-3 seconds in the height response and remarkably low variation of the results at different velocities. Computational fluid dynamics is then used to investigate and simulate the impact of introducing smart effector arrays on a UAV. The smart effector array produces a form of active flow control by providing localised flow field changes. These induced changes have direct impact on the aerodynamic forces and showed a substantial increase of lift at low angles of attack. There was also a significant increase to the lift to drag ratio at high angles of attack which resulted to a delay in stall.
Supervisor: Not available Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.577971  DOI: Not available
Keywords: TL Motor vehicles. Aeronautics. Astronautics
Share: