Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.577445
Title: Incorporating active control of human-induced vibrations in floors into buildings
Author: Hudson, Emma J.
Awarding Body: University of Sheffield
Current Institution: University of Sheffield
Date of Award: 2013
Availability of Full Text:
Access through EThOS:
Access through Institution:
Abstract:
This thesis investigates the implications of incorporating active vibration control (AVC) into floor structures from the initial design stage, with the goal of enabling the construction of more slender long-span floors. The original contributions to knowledge in this work are the investigations into: the development of a novel walking force that simulates the in-service loading of an office environment; the comparison between the effectiveness of AVC and tuned mass dampers (TMDs) when used on floor structures; the investigation into the effect of AVC over the entire floor area rather than considering single locations only, leading to conclusions about typical numbers of actuators that would be required; the investigation into the trade-off between power demand and the performance of an AVC system; and the initial life cycle analysis (LCA) of a floor that incorporates AVC at the design stage. The force model utilises simultaneous pedestrians walking throughout the structure and was calibrated and verified using experimentally acquired data. AVC was found to be a significant improvement upon TMDs in that the response of the structure was reduced to a greater extent using a much smaller inertial masses. The effectiveness of AVC was generally limited to within a single bay. However, large reductions in response were observed within each controlled bay. Therefore, it is suggested that a rule of thumb of one actuator per significant panel is required to control a given floor area, and that the size of these bays should be maximised to increase the effectiveness of AVC. High feedback gains resulted in only slight improvements in structural response, therefore improvements in the non-overhead power demand for AVC can be achieved through a simple decrease in the feedback gain. This has the additional benefit that smaller actuators could be utilised. The initial LCA highlighted the high financial cost of AVC but also demonstrated that potentially significant material savings could be realised through incorporation of AVC at the design stage.
Supervisor: Reynolds, P. Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.577445  DOI: Not available
Share: