Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.566519
Title: Effect of accumulated dust on the performance of photovoltaic modules
Author: Qasem, Hassan
Awarding Body: Loughborough University
Current Institution: Loughborough University
Date of Award: 2013
Availability of Full Text:
Access through EThOS:
Access through Institution:
Abstract:
Dust accumulation on photovoltaic (PV) modules and its effect on their performance are of high concern for regions with a high rate of dust, low frequency and intensity of rain. In this thesis, the effect of dust on PV modules is investigated with respect to dust concentration and spectral transmittance. The measured spectral transmittance of the dust sample shows spectral attenuation effect that varies at different wavelengths. This effect is explained by the particle size distribution of the dust samples: At shorter wavelengths more light is scattered due to the effect of the smaller particles. This effect has a major impact on the PV module as it affects PV technologies with a wider band-gap more than those of a narrower band-gap. The effect of dust is accumulative, i.e. PV module performance is reduced by increasing deposition over time or until it's cleared manually or by rain. The tilt angle of the PV installation plays a major role in the amount of dust accumulated on the devices, where higher tilt angles result in decreased dust concentrations. This effect is demonstrated in outdoor measurements where tilted modules had lower losses in daily as well as total array yield. It is also shown that tilted modules benefit from precipitation more than horizontal modules. However over the exposure period the modules did not show any clear aging effect caused specifically from dust accumulation or exhibit any seasonal variation. Different tilt angles can produce varying non-uniform dust patterns on the device surface. This effect and its pattern over long and short periods of exposure are investigated by means of spatial three dimensional modelling. The simulations compare two dust accumulation patterns that represent a short exposure to a single dusty day (one day) and a long exposure of dust (3 months). Out of the two patterns, the long exposure patterns showed higher losses of 19.4% in comparison to 14.8% for the short exposure. The simulation also showed that dust accumulation that promotes high concentration of dust at the bottom of the PV modules where it covers a full cell has a high risk of triggering hot spots and thus risks permanent module damage. A dust correction model for energy prediction is developed. The model takes into consideration dust concentration, spectral attenuation effect of dust, PV technology, and various meteorological variables. The modified spectral transmittances of the dust were incorporated into the model in the form of pre-measured data. This means in this work samples collected in Kuwait were measured and used to generate the input. The model is compared against the outdoor measured data and a good agreement between measurements iv and simulations is demonstrated. Using this model two procedures were developed. The first evaluates the uncertainties associated with dust over long periods of time. The second is to find the optimised cleaning schedule and frequency of cleaning based on acceptable yield loss margins over the simulated period of time. The optimisation of the cleaning schedule showed that for Kuwait setting the daily energy losses in PV modules at less than 10% will set the cost of cleaning higher than the cost of energy lost due to dust.
Supervisor: Not available Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.566519  DOI: Not available
Keywords: Photovoltaic ; Dust ; Accumulation
Share: