Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.562797
Title: Flow boiling and two-phase flow instabilities in silicon microchannel heat sinks for microsystems cooling
Author: Bogojević, Dario
Awarding Body: University of Edinburgh
Current Institution: University of Edinburgh
Date of Award: 2010
Availability of Full Text:
Access from EThOS:
Full text unavailable from EThOS. Please try the link below.
Access from Institution:
Abstract:
Flow boiling in microchannels, while very promising as a cooling technology in electronics thermal management, is still a subject being explored that requires further investigation. Before applying this technology for high heat flux computer chip cooling, challenging issues such as fully understanding boiling mechanisms in confined spaces, extending and stabilising the nucleate boiling regime, suppressing flow boiling instabilities, maintaining uniform flow distribution among microchannels, have to be addressed. If flow boiling is to be used as a thermal management method for high heat flux electronics it is necessary to understand the behaviour of a non-uniform heat distribution, which is typically the case observed in a real operating computer chip. In this study, flow boiling of deionised water in a silicon microchannel heat sink under uniform and non-uniform heating has been investigated with particular attention to flow boiling instabilities. An experimental system was designed and constructed to carry out the experimental investigations. The experimental heat sink consisting of forty parallel rectangular microchannels with 194 μm hydraulic diameter together with integrated inlet and outlet manifold was fabricated on a silicon wafer using inductive coupled plasma dry etching, in conjunction with photolithographic techniques. A design with integrated temperature sensors made from a thin nickel film allows local temperature measurements with a much faster response time and smaller thermal resistance as compared to temperature measurements using thermocouples. The integrated heater was designed to enable either uniform or non-uniform heating (hotspot investigation) with a low thermal resistance between the heater and the channels. Numerical simulations for single phase flow in adiabatic conditions were used to assist the design of the manifold geometry in the microchannels heat sink. Microfabricated temperature sensors were used together with simultaneous high speed imaging in order to obtain a better insight related to temperature fluctuations caused by two-phase flow instabilities under uniform and non-uniform heating. Two types of two-phase instabilities with flow reversal were identified and classified into flow stability maps. The effect of inlet water temperature on flow boiling instabilities was experimentally studied, with the influence of different subcooling conditions on the magnitude of temperatures as well as the influence on temperature uniformity over the heat sink being assessed. The effect of various hotspot locations on flow boiling instabilities has been investigated, with hotspots located in different positions along the heat sink. Bubble growth and departure size have been experimentally investigated. The results of this study demonstrate that bubble growth in microchannels is different from that in macroscale channels. Furthermore, the effects of bubble dynamics on flow instabilities and heat transfer coefficient have been investigated and discussed.
Supervisor: Sefiane, Khellil. Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.562797  DOI: Not available
Keywords: Flow boiling in microchannels ; computer chip cooling ; non-uniform heat distribution ; bubble growth in microchannels
Share: