Use this URL to cite or link to this record in EThOS: http://ethos.bl.uk/OrderDetails.do?uin=uk.bl.ethos.531871
Title: Actuation and control for robotic physiotherapy
Author: Richardson, Robert C.
Awarding Body: University of Leeds
Current Institution: University of Leeds
Date of Award: 2001
Availability of Full Text:
Access through EThOS:
Access through Institution:
Abstract:
Over the last few years researchers have developed prototype robots that are capable of administering physiotherapy, however, these devices tend to be complex and expensive. The use of modem pneumatic servo systems as actuators would make such devices simpler and cheaper. This thesis assesses the feasibility of a pneumatically actuated robotic physiotherapy device through the implementation of force and position control strategies. Traditional pneumatic servo systems consist of a pneumatic cylinder prone to stiction effects and a single spool valve. Here the performance of modem pneumatic servo system, consisting of a low friction pneumatic cylinder and two electropneumatic proportional valves has been evaluated. The increased linearity of the modem pneumatic system enabled a self-tuning pole-placement controller to be implemented that would be unsuitable for conventional pneumatic systems. The selftuning pole-placement controller enabled consistent and accurate position control. Other researchers have achieved force control of pneumatic systems, however their force models are not applicable on this modem configuration. Accurate control of the servo system force output, while the position of the cylinder piston is fixed, has been achieved through an open-loop force controller, however applications for fixed position force control are limited. The servo system force output, during motion, has been found to be a function of the piston velocity and input control signal. A pneumatic robot has been designed and fabricated with a position workspace that enables the average male to perform upper limb reach and retrieve exercises when attached to the robot. The pneumatically actuated robot, combined with a simple three degree-of-freedom force sensor, form a device capable of administering upper-limb robotic physiotherapy. Impedance control has been identified as the most suitable force and position control strategy for implementing physiotherapy. Applying the impedance control strategy, to a single link of the robot, resulted in accurate implementation of the desired force and position relationship. Extending the controller to two and three degrees of freedom has resulted in degradation of the controller performance due to limitations of the three degree-offreedom force sensor. The controller performance is also found to be dependent upon selection of the impedance characteristics. Low stiffness and high damping, along with high stiffness and high damping have been identified as particular low points in controller performance due to the requirement for the system to provide large forces with little resulting motion. It was concluded that the pneumatic robot and impedance control strategy have the potential to administer physiotherapy. However, further work incorporating a force sensor with greater accuracy that is robust to torque inputs and a rigorous stability analysis would be required before the device could be clinically evaluated.
Supervisor: Brown, M. D. ; Fisher, J. ; Plummer, A. R. Sponsor: Not available
Qualification Name: Thesis (Ph.D.) Qualification Level: Doctoral
EThOS ID: uk.bl.ethos.531871  DOI: Not available
Share: